3D printing of plastics often leads to shrinkage and wrapage of components. Because each component could have a different surface area and volume, the distortion in shape greatly varies between different shapes of components. This poses significant challenge in 3D printing of simple joints and fits that are used to connect two components together.
The challenge is to come up with a calibration curve for a typical joint of two components which will act as a ready reference for engineers
Integrated circuits have been designed for a long time now, and have aided the developement of hardware in a big way. Most of the analog and digital circuts are possible to be implemented in ICs, but inductor is still not possible to be put in ICs.
There is a need to miniaturize inductors and design them into ICs (integrated Curcuits) to allow for low real estate requirement on pcbs and also reduce losses, and also help in EMI / EMC testing.
In hospitals patients need to be shifted from wheelchair to stretcher, stretcher to beds, bed to wheelchair, or vice versa; which creates unsafe conditions for patients. Also transferring the patients from wheelchair to stretcher, stretcher to beds, bed to wheelchair is always an issue for the attendant or nurse.
There is a need for a wheelchair cum stretcher to facilitate the disabled patient’s mobility and to provide novel medical equipment for use in the Indian hospitals.
Crop health monitoring is an area which requires lot of attention as a wrong action taken would lead to crop failure. Farmers face issues in determining the optimum amount of water required for a crop, tracking crop development on a real time basis and detecting crop health issues.
The challenge is to design a smart application to provide insights on crop development, identify areas of crop stress, and provide alerts on water usage and irrigation requirements to maximize the crop yield.
Incinerator is a device that burns the waste without the use of oxygen and without giving out fumes. The proposal is to make a small house hold waste incinirator that can run on a smallest possible solar panels.
Existing pumps in the farm lands are not able to deliver at full potential because of the discontinuity of the electric power supply, presently available solar water pumps usually runs with DC and are different from the common sub-mercible pumps. The proposal is to make solar drive that can run existing sub mercible pumps with solar energy without the use of batteries
It is a known fact that the traditional, internal combustion engine based vehicles generates lots of emissions which are bad for health and environment. To overcome this, there is a lots of development already happening in the electric vehicle and hybrid vehicle technologies. It will be good if we can develop a system which will filter pollutant gases from the vehicle emission. This system also can be retrofitted into existing vehicles so that they are less polluting.
Design a Plastic enclosure for Electronics circuit board for communication devices. This Product will assemble in the sheet metal frame cut outs. The requirement defined not use screw in the metal frame. The Sheet metal cut-out have 1mm to 10mm thickness (different Frames but same product to be used) and remove the product from the cut-out required 100N pull force. Challenge –Snap Design (plastic) were can with stand the 100N pull force
Immersive experience is a trend where people interact & perceive real world through digital medium. How great would it be to experience anything digitally before experiencing it in the real world? This can be made possible with either Virtual Reality (VR) or Augmented Reality (AR). The challenge is in creating immersive experience with LiDAR point cloud data. We are looking to create a VR Shell app that can create immersive experience using point cloud data as input.